- Factory
- Mold tooling
- Mould steel
- Plastic Material
- Delivery time
- Payment terms
- Yunpeng advantage
- Yunpeng mould advantage 2
- 3D Drawing Format
- Yunpeng Certificate
- Service
- Manufacture plastic parts
- 3 D Printing
- Delivery Terms
- Die casting
- Quality
- Mold Wiki
- Mold Layout/Design
- Mold Layout Design
- do you know about" Injection molding"
- Mold Structure
- Mold problems
- Hot Runner
- Two shot plastic injection molding
- Cavity
- Parting Line
- How to Determine Parting Line of mold products?
How to control die crack
1. Die poor follow-up processing of materials that can easily fracture
2. Heat treatment: quenching and tempering process improper deformation
3. Mold and insufficient ground plane, resulting in deflection
4. The design process: mold strong enough, blade pitch too close to the mold structure is irrational, mold plate simply was not enough non-plate pad feet
5. Mishandling of cut wire: Pull-line cut, the gap is incorrect, no angle to make clear
6. Punch the selection of equipment: punch tonnage blanking force is not enough, transfer mode too deeply under the
7. Off material will not ring true: no demagnetization treatment pre-production, no tip is expected retreat; the production of a Broken Needle spring break materials such as card
8. Blanking not ring true: when the seamless assembly of mold feces, or roll blocking feces, feces blocking pad feet
Hi I am Tea, my email is injectionmold2006@163.com
- Name:
- Louis
- Tel:
- 86-18667882836
- 86-18967854492
- 86-0574-62001718
- whatsapp:
- 86-18667882836
- skype:
- lzylzy8760
- Address:
- number 36 .yujinggen road.yuyao city .zhejiang province
