- Factory
- Mold tooling
- Mould steel
- Plastic Material
- Delivery time
- Payment terms
- Yunpeng advantage
- Yunpeng mould advantage 2
- 3D Drawing Format
- Yunpeng Certificate
- Service
- Manufacture plastic parts
- 3 D Printing
- Delivery Terms
- Die casting
- Quality
- Mold Wiki
- Mold Layout/Design
- Mold Layout Design
- do you know about" Injection molding"
- Mold Structure
- Mold problems
- Hot Runner
- Two shot plastic injection molding
- Cavity
- Parting Line
- How to Determine Parting Line of mold products?
Do you how to choose right place about products parting line?
Parting lines on plastic parts

One has to keep in mind what the plastic mold will look like when designing plastic parts. The green part at right shows an example of good and bad stepped parting line. When looking at the part, it might not be so obvious, but take a look at the mold steel shown below it.
As we see, the mold steel on the one side has a sharp edge to it. That edge will break down quickly, resulting in ugly looking plastic parts.
When people with no experience in designing plastic injection molds design plastic parts, these kinds of mistakes are very common. Send a part like that to a third world country to have the mold built, and the plastic injection mold will likely be built exactly as you designed the part, resulting in very poor quality plastic parts.
Feel free to contact me for consulting or design help.
Hello,i am Cherry,if you need any help,pls contact me via email:injectionmold2008@163.com Whatsapp:+86 15112289056
- Name:
- Louis
- Tel:
- 86-18667882836
- 86-18967854492
- 86-0574-62001718
- whatsapp:
- 86-18667882836
- skype:
- lzylzy8760
- Address:
- number 36 .yujinggen road.yuyao city .zhejiang province
