MOLD&MOULDING SOLUTIONS
FAQ
- Factory
- Mold tooling
- Mould steel
- Plastic Material
- Delivery time
- Payment terms
- Yunpeng advantage
- Yunpeng mould advantage 2
- 3D Drawing Format
- Yunpeng Certificate
- Service
- Manufacture plastic parts
- 3 D Printing
- Delivery Terms
- Die casting
- Quality
- Mold Wiki
- Mold Layout/Design
- Mold Layout Design
- do you know about" Injection molding"
- Mold Structure
- Mold problems
- Hot Runner
- Two shot plastic injection molding
- Cavity
- Parting Line
- How to Determine Parting Line of mold products?
How to Determine Parting Line ?
Update Time:2017-12-08
The term "parting line" refers to the location at which the cavity insert, the core insert, and the plastic molding meet. Since the core and cavity insert meet at this location, any significant deflection of the cavity insert away from the core insert will result in a gap into which the plastic will flow and form a thin film of plastic known as "flash" . Imperfections in the core and gaps into which the plastic will flow.. Even with new and well-crafted molds, the location of the parting line usually results in a very slight "witness line" along its length..
For this reason, the parting line should be located along a bottom edge of the part, or some other non-visual, non-functional edge. Consider the previous cup shown in Figure 4.1.
Placing the parting line very close to the lip as indicated by the dashed line in the left drawing of Figure 4.6 would result in a witness line and possible flash that might make the molded cup unusable, Alternatively, a better location for the parting line is at the bottom of the rim as indicated in Figure 4.2, corresponding to the parting line shown in the right drawing of Figure 4.6.
Hello,i am Cherry,if you need any help,pls contact me via email:injectionmold2008@163.com Whatsapp:+86 15112289056
NAVIGATION
