News Group
- YP mould
- Update news about our YP plastic injection mould
- How to get the injection products of the best prec
- Mold knowledge
- Customers visit our factory
- How to make injection mold with high qulaity?
- two shot plastic injection molding and it's functi
- Two shot plastic injection molding and it's functi
- What is a hot runner mold
Specify Vent Dimension
Issue Time:2017-12-08
Specify Vent Dimension of Plastic Injection Mold
Once the number of plastic injection mould vents is specified,the rate of air flow through each vent can be calculated.It may seem reasonable to estimate the air flow through each vent as the total volumetric air flow divide by the number of vents.However,this approach would not be conservative.The reason of inejction molding is that the exact location of the end of fill is not known.As such,it is possible that much of the air flow can disproportionately favor any one of the four locations on each side of the part.A more conservative approach is to assume that all the local air flow exits through each available vent.
- if you need help, pls contact me, I am Tea, my email is injectionmold2006@163.com
- whatsapp+8615958816137 skype:injectionmold2006@163.com
NAVIGATION
