- 3D printing & Prototype
- Home Appliances Plastic Mould/Molding
- Overmolding Mould/Molding
- Electronic Plastic Mould/Molding
- Medical Plastic Mould/Molding
- Industrial Plastic Mould/Molding
- Commodity Plastic Mould/Molding
- Auto plastic mould/molding
- Packaging Plastic Mould/Molding
- Stamping Mould & Die Casting
- Silicone Mould/Molding
- Blowing Mould/Molding
News Group- YP mould
- Update news about our YP plastic injection mould
- How to get the injection products of the best prec
- Mold knowledge
- Customers visit our factory
- How to make injection mold with high qulaity?
- two shot plastic injection molding and it's functi
- Two shot plastic injection molding and it's functi
- What is a hot runner mold
CertificatesActuate Quickly and Reliably
The ejection stage consumes precious seconds of the molding process,without providing much value to the moldings.As such,the ejection system should be designed to remove the moldings as quickly and reliably as pissible,and then reset so that the mold may be closed and the next cycle initiated. To increase the speed of the ejection system,some molders may specify the use of air poppets and/or air jets to improve ejection velocities and reduce the cycle time.
To increase the reliability of the ejection system,the mold designer should develop the mold to tightly interface with the molder's preferred part removal system.While many molds rely on gravity drop of the moldings and the feed system to a moving conveyor,molders are increasing using sprue pickeres and gantry robots for part removal. In general, these systems do not greatly redudce the molding cycle time but rather provide increased control of molding's removal and subsequent placement while protecting while protecting the aesthetic areas. If sprue pickers or robots will be used, then the mold designer must appropriately customize the ejection system, Typically, the moldings must be stripped off the core but retained at a controlled position by some of the ejection system compontents. Furthermore,mold designers should confirm and design interface geometry in the cavity and/or feed system that is easily identified and highly repeatable for interfacing with the part removal system.
If you need help,please contact me.I am Lisa,my email is injectionmold2005@163.com skype/whatsapp+86 15617940830
Previous Actuate Quickly and ReliablyNext Mold Layout DesignNAVIGATION- 3D printing & Prototype
- Home Appliances Plastic Mould/Molding
- Overmolding Mould/Molding
- Electronic Plastic Mould/Molding
- Medical Plastic Mould/Molding
- Industrial Plastic Mould/Molding
- Commodity Plastic Mould/Molding
- Auto plastic mould/molding
- Packaging Plastic Mould/Molding
- Stamping Mould & Die Casting
- Silicone Mould/Molding
- Blowing Mould/Molding
CONTACT US- Louis
- leave a message:
- Contact Now
- Address:
- number 36 .yujinggen road.yuyao city .zhejiang province
Copyright © 2021 Yuyao City Yunpeng Plastic Mould Co.,ltd Support By BEE Cloud